123

Oyaide C-029 / P-029

Name of product P-029 / C-029
blade brass
Cable adaptation outside diameter Min 6.5mm maximum 17.0mm
The maximum cable adaptation gauge AWG10 (5.5sq)
Rating 125V · 15A specification E certified product

 

And each one of the parts are combined, in one of the power plug

Wide contact area (IEC)

Blade receiving portion in contact with the inlet, use of 1.4mm thick brass. 
This achieved a strong sense of holding. Load capacity of a typical IEC connector electrode is usually 3 ~ 5kg but, C-029 will be holding the inlet electrode with a force greater than 7kg. 
And more difficult to pull it out, is a plug that can be used with confidence not budge even a little vibration.

Contact to withstand tensile load of 30kg

Tensile strength of the blade receiving portion and the cable is not such thing as coming missing also a little tension in the 30kg or more. This also is the result of careful consideration of the safety.


Selection without compromise is not the only electrode portion parts

Non-magnetic stainless steel screws commitment pulled from one

 

Commitment ELEC product sticks from one screw. 
P / C series is a screw that is used to is, P / C series-made custom-made stainless steel screws for, non-magnetic material is also, of course, by the fine thread pitch, body and cover it took a lot of the area of contact. 
As a result the body and the cover is hard to distortion, also it has a making pile loose screws.

 

In addition to too much torque, or there is no experience that had crushed a thread? Because you are using all screws class stainless steel that is used in our plug, screw mountain to collapse even if too much torque, there is no such head can be taken. In addition, because stainless steel itself non-magnetic material, we will provide a high sound with S / N without ObiShigeru in the connector part.

GF + PBT body

The body was used for high-density engineering plastic material PBT + GF30% with a proven track record in the SWO-DX.As a result, rather than to absorb the vibration, it attenuates high-speed Osaekomi vibration.

High rigidity Polycarbonate

The body cover, we used the thickness Polycarbonate. Selection of this material is its strength and hardness. Weak vibration response soon dampen, there is no Tameibitsu sense of enhanced rigidity.

 


Cable adaptation outside diameter

When you own a power cable, wind or butyl for the purpose of vibration control, or there is no experience that has become catapult thick using the noise cut-off tape, and the like? This product is so designed to be used with confidence to such customers, IEC plug, it can corresponding to the maximum outer diameter of 17mm cable to the power plug both. Now, even if has become carelessly thick with tape and seismic processing, and the other peace of mind.

 

※ When you remove the clamper, the cable up to 17mm can be used.

Cable mounting holes

I want only to use a thick cable can be, I want to make! For such customers, cable attachment size can accommodate up to a maximum of 10sq (5.5sq × 2 pcs.) (However permissible current 125V15A)


Management system by serial number with a hologram seal

ELEC electricity P / C (plug / connector) for management in the series, all is stuck the hologram seal with a serial number. In addition, since the factory is a state that went into the original cans case, it will protect the body from impact during transport.